Mechanical anchor

For securing single sided formwork to rock or concrete walls. Hole diameter required: 35mm–37mm. Conduct tensile tests before applying final load. A rock anchor for 20mm tie rod is available. Technical details on request.

Form Anchor

The Form-Anchor is versatile, noncorrosive and used mainly for securing single-sided and climbing formwork. Easily fixed using the plastic cone locator enabling quick formwork erection, with no drilling of plywood. Can also be used for securing slab edge formwork, guard rails, etc. For use with 15mm Dywidag Thru Tie Rods.

Uni-Sleeve Anchor

The Uni-Sleeve has a 65mm long internal thread for 15mm tie rods and is ideal for:

• single-faced formwork
• edge formwork
• scaffolding brackets
• general guard rails

Safe working load: 27 kn.

Assembly:

• The cone is nailed to the formwork with pre assembled nail.
• Push on Uni-Sleeve
• Concrete and then remove formwork
• Screw in tie rod as required
• With the special sealing groove, the sleeve closes tightly preventing concrete from entering the sleeve.

Weldable Anchor – Fitsch

A metal anchor which can be welded to RSJ’s, sheet piling and other metal structures to accept 15mm tie rod. Anchors must be welded continuously all the way round – load tests should be conducted before use.

Drop in Anchor 15mm

A drop in Anchor specifically designed for the use with 15mm Formwork Tie Rod Bars. It is ideal for low load applications, such as fixings for hand rails into existing concrete. For safety reasons we state that admissible loads for a low concrete strength of 15 M/mm. This means in practice that the anchors are often installed the next day after concreting and are already loaded.

APT Anchors

The new APT anchor range of fixings provide the construction professional with a single fixing anchor for the majority of fixing needs. A fixing for all substrates. No plugs or inserts needed.

• Single thread design to give maximum grip with minimum insertion torque.
• Balancing thread designed to ensure correct alignment of anchor with drilled hole.
• One piece fixing for ease of installation and reduced cost.
• Uses standard drill sizes
•Threading system allows for total removal of anchors from substrates.
• Self tapping multi-substrate anchor

Robusta Vertical Positioner

The Robusta vertical installation kit is the perfect solution for avoiding drilling holes into concrete slabs after they have been poured to accept 15mm Dywidag thread bars.

Installation takes place prior to the slab being poured, leaving ideal anchor points for props, handrails etc after pouring.

The units consist of four main component, the body, a hollow threaded tube section, the threaded plastic plate for fixing to the reinforcement mate and the marking plug with aerial that allows the tube to be located after pouring of the slab.